100% original new and brand P+F KFD2-HMM-16 HART MUX Primary Module high quality and good performance

Product description:

16-channel

24 V DC supply (Power Rail)

HART field device input (revision 5 to 7)

Up to 15 KFD0-HMS-16 HART MUX secondary modules can be connected

Up to SIL 3 acc. to IEC/EN 61508

The HART MUX primary module operates up to 256 analog field devices. The built-in secondary module in the primary module operates the first 16 field devices. If more than 16 field devices are required, up to 15 additional HART MUX secondary modules KFD0-HMS-16 can be connected.

The secondary modules are connected to the primary module with a 14-pin flat cable. The connector for the ribbon cable is found on the same housing side as the connectors for the interface and the power supply.

The analog signals are separately linked via a 26-pin flat cable to each secondary module. Sixteen leads are reserved for the HART signal of the analog measurement circuits. The remaining 10 leads are assigned to ground.

The primary module is designed with removable terminals and can be connected to the Power Rail.

• 
  

• 
  

• 
  

• 
  

• 
  

• 
  

• The HART MUX primary module operates up to 256 analog field devices. The built-in secondary module in the primary module operates the first 16 field devices. If more than 16 field devices are required, up to 15 additional HART MUX secondary modules KFD0-HMS-16 can be connected.

• The HART MUX primary module operates up to 256 analog field devices. The built-in secondary module in the primary module operates the first 16 field devices. If more than 16 field devices are required, up to 15 additional HART MUX secondary modules KFD0-HMS-16 can be connected.

• The secondary modules are connected to the primary module with a 14-pin flat cable. The connector for the ribbon cable is found on the same housing side as the connectors for the interface and the power supply.

• The analog signals are separately linked via a 26-pin flat cable to each secondary module. Sixteen leads are reserved for the HART signal of the analog measurement circuits. The remaining 10 leads are assigned to ground.

• The primary module is designed with removable terminals and can be connected to the Power Rail.

• The secondary modules are connected to the primary module with a 14-pin flat cable. The connector for the ribbon cable is found on the same housing side as the connectors for the interface and the power supply.

• The analog signals are separately linked via a 26-pin flat cable to each secondary module. Sixteen leads are reserved for the HART signal of the analog measurement circuits. The remaining 10 leads are assigned to ground.

• The primary module is designed with removable terminals and can be connected to the Power Rail.