Flexible Pepperl+Fuchs KFU8-UFC-Ex1.D Frequency Converter with Trip Values for NAMUR Sensors, Speed Monitoring, and Alarm Control
Flexible Pepperl+Fuchs KFU8-UFC-Ex1.D Frequency Converter with Trip-Value Monitoring for NAMUR Sensors and Contact Inputs
KFU8-UFC-Ex1.D combines frequency conversion, speed monitoring, indication, and trip-value evaluation in one configurable isolated barrier. Its wide-range power supply makes it particularly useful where a cabinet does not provide the 24 V DC Power Rail normally associated with K-System modules.
From Field Pulses to Useful Process Information
A NAMUR proximity sensor or dry contact can provide pulses that represent shaft speed, conveyor movement, flow, or machine cycles. KFU8-UFC-Ex1.D evaluates those pulses and converts the frequency into an analogue process value. At the same time, configurable outputs can support alarms, switching actions, or status reporting when the measured frequency crosses a defined limit.
This arrangement is valuable when a control system needs more than a simple pulse count. The module can present a scaled signal for trending while independently monitoring operating limits such as low speed, high speed, standstill, or process deviation.
Operator-Friendly Configuration
The front display and keypad provide direct access to operating values and configuration parameters. For more detailed setup, compatible software can be used through the programming interface. Clear front-panel indication helps maintenance personnel distinguish normal operation, input activity, output status, and fault conditions during commissioning or troubleshooting.
What type of pulse source is connected?
What frequency range represents normal operation?
Is a 0/4-20 mA output required for the control system?
Which trip limits, relay actions, and start-up behavior are needed?
Does the project require hazardous-area approval or a specific safety level?
Where KFU8-UFC-Ex1.D Is Commonly Considered
Typical applications include pump and fan speed monitoring, conveyor supervision, turbine or motor rotation checks, frequency-to-current conversion, machine-cycle counting, and alarm generation from NAMUR sensors. KFU8-UFC-Ex1.D can also be useful as a direct replacement when an existing panel already depends on its supply range, terminal layout, and configured output behavior.
Before replacing the module, record the parameter settings as well as the full model number. Two units with the same hardware can behave differently if their scaling, trip values, hysteresis, or output logic are not configured identically.
Other hot sales models for your reference.
KFD2-UFC-Ex1.D, KFU8-GUT-Ex1.D, KFU8-DWB-1.D, KFU8-CRG2-1.D, KFD2-DWB-Ex1.D, KFD2-ST3-Ex2, KFD2-SR2-Ex1.W, KFD2-SR-Ex1.4S.LK, KFD2-STC5-Ex1, KFD2-STC4-Ex1.2O, KFD2-UT2-Ex1, KFD2-EB2, KCD2-STC-Ex1.ES, KCD2-SR-Ex1.LB, and KFD0-CS-Ex1.51P.
Latest News
-
Non-Contact Pepperl+Fuchs UB500-18GM75-I-V15 Ultrasonic Sensor with 4-20 mA Output for Distance, Position, and Level Measurement…
November
19, 2026
-
Compact Pepperl+Fuchs NJ2-12GM-N NAMUR Inductive Proximity Sensor for Hazardous-Area Valve Position and Machine Detection…
November
19, 2026
-
Dual-Output Pepperl+Fuchs KFD2-STC4-Ex1.2O SMART Transmitter Power Supply for HART Loops, DCS Inputs, and Signal Splitting…
November
19, 2026
